MEMS, imaging, temperature, current, position and environmental sensing.
We cover new sensing devices and the details that shape their use, from where a current sensor can fit on a board to whether a replacement needs recalibration.
AND Technology Research helped fit a heel sensor, battery and adjustable haptics into a prototype that can flex inside a shoe.
The accelerometer can wake the host for a motion event or hold a batch of readings until the processor needs them. ST’s lowest current figure applies at 1.6 Hz.
The MLX90636 measures surface temperature. Estimating core temperature from the wrist depends on the optics, the device and how the wearer responds to their surroundings.
The debugger was giving a peripheral time to wake up. With that fixed, the next case follows a sensor that keeps drawing current after its supply has been switched off.
A thermocouple input can drift as its enclosure warms even when the sensing junction is stable. The error can start at the terminals, before the signal reaches the converter.
The module performs local human and object detection, then crops and compresses event images instead of continuously streaming video.
The IMPM detector combines pyroelectric and thermopile channels, with a wide motion-sensing field and a narrower central field for presence detection.
A 128 × 128 research chip extracts temporal occupancy inside its pixels, using information normally lost when a camera integrates light into a frame.
The work spans long-range sensing on ground vehicles and airborne 3D mapping, with MOVIA purchases supporting further development and evaluation.
TDK’s robot demonstration brings position, motion, temperature and interference control into one component stack, showing how each measurement depends on the rest of the actuator system.
The near-infrared metaEye camera uses a solid optical stack above a 400 × 400 sensor, with eye tracking as its first application.
Two interferometers and phase processing allow a research accelerometer to follow motion beyond the narrow response region of a single optical measurement.
STMicroelectronics has released four combined accelerometer-gyroscope devices for automotive safety, its first products since acquiring NXP's sensor business.
A graphene inductor and custom conversion circuit charge capacitors that supply a temperature sensor operating at nanowatt power levels.
STMicroelectronics has released four combination inertial sensors integrating an accelerometer and gyroscope in one package for automotive active and passive safety systems.
The M704 and M705 share their nominal resistance and B value, but their mounting arrangements, temperature limits and reported thermal response differ.
Picomag measures flow electromagnetically, so its liquid has to be electrically conductive.
The worst position error in ADI’s reported robot trials fell from 1.923 m to 0.275 m after wheel measurements were integrated into NVIDIA’s cuVSLAM estimator.
Sony’s IMX742 sends digital video along a 5 m cable from a sensor measuring just 1 mm square.
Sensirion’s published schedule ends production and deliveries of four SDP5xx sensors on 26 October. Its suggested replacements offer two different routes, with different implications for firmware.
A stretchable conductor can be designed to change resistance dramatically or to keep carrying a signal. Textile electronics needs both behaviours, often very close together.
STMicroelectronics will inject Matter Device Attestation Certificates and keys into its ST25DA-C NFC tag and STSAFE-A120 secure element before shipment.
The Edge 1060 adds a microphone and speaker to a device that must work outdoors, on a moving bicycle and within a limited battery budget.
Fraunhofer’s MEMS amplifier work tackles a stubborn radio trade-off: listening for a message uses energy even when the main sensor has nothing to do.