News

Japan’s mobile fab will demonstrate wafer patterning in a truck

Japan’s mobileFab keeps half-inch wafers enclosed as they move between three lithography tools small enough to travel by truck.
The photolithography cleanroom at the London Centre for Nanotechnology.

The London Centre for Nanotechnology’s photolithography lab, shown for comparison with the portable demonstration.

Image: O. Usher / UCL Mathematical and Physical Sciences / Wikimedia Commons. ).jpg (unmodified) · CC BY 2.0

Japan’s Minimal Fab Promotion Organisation will put three wafer processing tools in a truck at SEMICON Japan in Tokyo from 9 to 11 December. One coats the wafer with resist, the next exposes the pattern without a physical mask and the third develops it. The demonstration ends with a pattern in the resist, before any material is etched or deposited.

The equipment comes from Japan’s National Institute of Advanced Industrial Science and Technology (AIST). Its Minimal Fab line processes wafers about 12.5 mm across, one at a time, in tools roughly 30 cm wide. Each tool keeps the area around the wafer clean and the wafer travels between tools in an enclosed carrier, so the room itself does not have to be a cleanroom. Using maskless exposure also lets the operator change the pattern without ordering a new mask.

Students at a college in Kumamoto already work with wafers supplied by AIST with the transistors in place. The students pattern the wiring and test the resulting circuits. The mobileFab team proposes doing the same with a portable set of tools for patterning, with etching and electrical measurements handled separately. A wiring revision could start with another preprocessed wafer from the same batch; a change to the transistors would go back to the fab.

The broader Minimal Fab system has already produced a working chip. In 2021 Yokogawa used the front-end tools at its application lab to prototype a small integrated circuit for the Japan Aerospace Exploration Agency. It used AIST’s silicon-on-insulator CMOS process and checked circuit operation on an oscilloscope. That took place in a lab with more process tools than the truck will carry.

The organisation aims to start educational use around April 2027. Its announcement gives no figures for how accurately the mobile tools can align successive layers or how many wafers they can process in an hour.

Sources: Minimal Fab Promotion Organisation announcement; AIST paper on low-volume semiconductor prototyping; Yokogawa’s JAXA prototype case study.

Continue reading