TI’s CAN XL transceiver combines 20 Mbit/s signalling with CAN FD support

Illustrative image: Mikhail Nilov on Pexels
Texas Instruments’ TCAN6062 combines CAN XL signalling at up to 20 Mbit/s with support for CAN FD networks, using two different ways of driving the bus within an eight-pin transceiver. Introduced by TI in August and available through Mouser, it shares pin layouts with several of TI’s existing CAN FD and CAN SIC devices, allowing those layouts to carry over as the controller and network move to CAN XL.
During FAST transmission, the TCAN6062 uses an H-bridge to drive both logic states actively, with receiver thresholds centred around zero. The controller requests this mode by varying the pulse width on the transmit input; in signal improvement capability (SIC) operation, the transceiver instead suppresses ringing as the bus moves from dominant to recessive. That helps signals settle on branched networks, with TI specifying up to 8 Mbit/s for SIC operation and reserving the 20 Mbit/s rating for FAST mode.
CAN XL also carries more data in each frame. Its payload can reach 2,048 bytes, compared with 64 bytes for CAN FD, allowing a block of sensor or software data to travel in fewer frames while retaining arbitration by message priority. The reduction in framing overhead accompanies the higher signalling rate, although both depend on a controller that understands CAN XL and can command the transceiver’s operating modes.
On the controller side, VIO accepts logic supplies from 1.71 V to 5.5 V, while the transceiver’s VCC supply is specified at 4.75 V to 5.25 V. This accommodates different controller I/O voltages without changing the physical layer device, and the familiar pin arrangement can ease the board changes needed to incorporate it.
The interface also supports remote wake requests in standby and presents high impedance at its bus and logic terminals when unpowered. Protection includes undervoltage detection, thermal shutdown and a dominant transmit timeout, together with a ±58 V fault rating on the bus pins. Package options are an eight-pin SOIC and a 3 mm × 3 mm VSON, whose wettable flanks allow solder joints to be checked by automated optical inspection.
Sources: Mouser stocking announcement; Texas Instruments product specifications; Texas Instruments August launch announcement; Mouser Europe catalogue, showing the September listing; TI technical background on CAN XL frames and arbitration.



