How Phoenix Contact’s EMpro meters fit into a control panel

Image: Mouser Electronics
Mouser says it is shipping Phoenix Contact’s EMpro AC energy meters, which it had already listed before the November stocking announcement. The range is intended for submetering, including billing between cost centres. Some models carry the load current themselves; others read it through external current transformers.
The single phase EEM-XM157 takes up to 45 A AC directly and the three phase EEM-XM357 takes up to 100 A AC. Both use Modbus RTU and need enough room in the cabinet to bring the load conductors to the meter terminals.
The three phase EEM-XM375 instead takes a 1 A or 5 A input from a current transformer fitted on the conductor being measured. That leaves more freedom over where to mount the meter, though the transformer adds its own accuracy limits and the meter needs the correct ratio to report primary current. The XM375 also uses Modbus TCP, which is a separate consideration if the existing supervisory system connects to its meters over a serial bus. Phoenix Contact lists all three models as certified under the EU Measuring Instruments Directive.
Sources: Mouser’s 12 November stocking announcement; Mouser’s existing range listing; EEM-XM157; EEM-XM357; EEM-XM375.



