Explainer

Murata details an isolated SiC gate supply with 2.5 pF across the barrier

The MGJ2T2 supplies +18 V and −3 V from a 24 V input, with reinforced insulation rated at up to 800 V RMS working voltage.
Macro photograph of circuitry in red light.

Illustrative image: Nic Wood on Pexels

Murata’s MGJ2T2 isolated converter supplies the positive and negative rails for a silicon carbide MOSFET driver while limiting capacitance across its isolation barrier to 2.5 pF. The 2 W device converts a 24 V input into +18 V and −3 V outputs, with Murata publishing detailed electrical ratings following its preview of the series before electronica.

At a high-side switch, the gate driver and converter secondary move in potential with the switch node. Fast voltage changes drive brief currents through the capacitance between the isolated secondary and primary supply, making that coupling a concern even though there is no direct conductive path across the barrier. Reducing the capacitance limits this displacement current for a given rate of voltage change.

Murata addresses the coupling through its Block-Coil transformer construction, which places separate windings on solid insulating formers. The physical separation helps achieve the 2.5 pF capacitance, alongside more than 8 mm of creepage and clearance in the package. The company also specifies common-mode transient immunity above 200 kV/µs, describing the converter’s ability to tolerate rapid voltage changes across the barrier.

On the isolated output, the −3 V rail allows the driver to hold the MOSFET gate below its source while the device is off, helping resist unintended turn-on during switching transitions. That negative bias accompanies the +18 V supply used to drive the gate, with both rails referenced to the local switch potential.

Insulation is rated for reinforced operation at up to 800 V RMS working voltage or basic insulation at up to 1,600 V RMS. Murata lists a separate 6 kV DC withstand test and says the converter was designed to meet IEC 60664-1, with a specified operating temperature range of −40 °C to +125 °C for the SIP device.

Among the applications Murata identifies are solid-state transformers built from cascaded converter stages. Each stage handles part of the total voltage and requires a gate supply referenced to its own local potential, repeating the need for isolation throughout the assembly as power passes through the series of cells.

Sources: Murata MGJ2T2 specifications and announcement; Murata’s October electronica preview.

Continue reading