Lattice FPGAs pass a year in orbit in TESAT laser terminals

Lattice’s Nexus FPGAs have completed more than a year in orbit inside TESAT optical communication terminals, where the company says they have performed as specified since launch in 2025. The terminals operate laser links at 10 Gbit/s and incorporate a platform TESAT selected during a redesign of its electronics, balancing radiation behaviour against power consumption and board area.
Those electronics have to operate for years without physical access, making recovery from radiation induced errors part of the design problem. Nexus uses a 28 nm fully depleted silicon-on-insulator process, in which a small active region and buried oxide reduce the volume of material susceptible to a particle strike. Lattice combines that process with circuitry that checks the FPGA’s configuration memory and can correct certain errors while the device operates.
The checks work frame by frame through configuration memory, detecting both single-bit and multiple-bit errors and supporting correction of a single-bit error within a frame. Correction must be enabled, and the time taken to complete it depends on the device size, checking clock and configuration settings. These are capabilities documented for the Nexus platform; TESAT has not disclosed the settings or recovery sequence used in its terminals.
Configuration recovery addresses changes to the stored pattern that defines the FPGA’s logic. It can restore that pattern after an upset, but cumulative radiation damage and destructive events remain separate constraints on device selection and mission life. The reported year of operation provides experience of the devices within a working optical terminal, alongside the platform’s radiation characterisation.
Lattice has not identified the FPGA variants or spacecraft involved in this installation. TESAT has flown laser terminals in both low Earth and geostationary orbit, while the Nexus families Lattice offers for space applications include Certus-NX, CertusPro-NX and CrossLink-NX. All are supported by its Radiant design software.
Sources: Lattice and TESAT announcement; Lattice Nexus configuration error detection and correction guide.



